Using Locks - Dish Network 311 User Manual

Chapter 3
Using the System
Page 42
6. Set the code for the VCR using one of the following:
• Enter the first 3-digit code number from the table using the
NUMBER PAD buttons.
• Highlight each digit of the first VCR code, and
then press the UP or DOWN ARROW button until
you reach the correct number and then press
SELECT.
7. Make sure the VCR is turned ON and the switch is set
to 3 or 4 (whichever you use). Insert a rewound tape on
which you want to record. The receiver starts the VCR recording, but
does not turn ON the VCR, so you must do this yourself.
8. To test the new code, highlight the
message warning you to make sure the VCR is turned ON.
9. Press the SELECT button to start the test. Your VCR
records for a few seconds, stops, and then rewinds. The
receiver displays a message saying that your VCR test is
complete. Follow the instructions on the message.
10. If your VCR did not complete the test, enter another code
from the table, and then repeat steps 5 through 8.
11. Once you have found the correct VCR code, select the
save the VCR code you entered and return to the
menu.
Setup
U L
SING OCKS
First you set the locks; then you lock the receiver. You must lock
the receiver in order to put any locks into effect. If you unlock
the receiver, leave the locks unchanged, and then lock the
receiver again, the same locks will be in effect as before.
H S L
OW TO ET OCKS
1. Create the locks that you want.
2. Lock the receiver.
Once the receiver is locked, anyone who wants to access locked items
must enter the password.
W Y H L
HEN OU AVE OCKED THE
If you try to access a locked item or open the
receiver displays a message prompting you to enter the password.
The receiver allows you three tries to enter the correct password. If you fail
to enter the correct password, the receiver does not allow more tries for
several minutes.
Test
: A T S P
WO TEP ROCESS
R
ECEIVER
option. The receiver displays a
option to
Save
Installation and
menu, the
System Locks