Dish Network 311 User Manual page 72

Chapter 4
Reference
B P -P
UYING A AY
What Is
Happening
Someone orders a pay-
per-view program without
your permission.
You find that you are not
able to order a pay-per-
view program.
You find that you are not
able to cancel a pay-per-
view program.
Your setup includes more
than one receiver. You
order a pay-per-view
program, but it does not
appear via all of the
receivers.
U T
SING THE ELEPHONE FOR
What Is Happening
While you are making a
telephone call, you hear
"clicks."
The receiver cannot connect
to DISH.
You pick up the telephone to
make a call, but you do not
hear a dial tone.
Your computer or facsimile
(FAX) machine tries to send
a FAX or modem
transmission, but fails.
Your computer or FAX
machine was receiving a
FAX or modem
transmission, but an error
occurred.
Page 66
-V P
ER IEW ROGRAM
Possible Reason
You may have been away from the
receiver, and someone else used it.
The receiver may not be connected
to an active telephone line.
The credit limit may have been
exceeded.
You ordered a pay-per-view
program, and then decided not to
watch it.
You ordered a pay-per-view
program and want it to be available
via all the receivers in your setup.
V /D
OICE
Possible Reason
The receiver may have tried to call the
Customer Service Center to send pay-
per-view purchase information. When
the receiver found that the telephone
was busy, it automatically
disconnected.
Maybe the receiver is connected to a
DSL (Digital Subscriber Line) phone
line.
The receiver was calling the Customer
Service Center to send pay-per-view
information. When the receiver found
that the telephone was busy, it
automatically disconnected.
The receiver was calling the Customer
Service Center to send pay-per-view
information. When the receiver found
that the telephone was busy, it
automatically disconnected. The FAX
or modem found that there was no dial
tone and cancelled the transmission.
The receiver may have tried to call the
Customer Service Center to send pay-
per-view purchase information during
the FAX or modem call. When the
receiver found that the telephone was
busy, it automatically disconnected.
This generated "clicks" that caused an
error in the FAX or modem
transmission.
Lock the purchase of pay-per-view programs. Remember that you
are responsible for all pay-per-view purchases, whether or not you
authorize such purchases. If you lock pay-per-view purchases, then
anyone who wants to order a pay-per-view program must enter the
password.
You must connect the receiver to an active telephone connection at
all times. If you install two or more receivers, you must connect
each receiver to an active telephone connection at all times.
Review your pay-per-view purchases to check the credit limit.
You cannot cancel an order for a pay-per-view program, whether it
was just ordered or ordered earlier.
If you want to watch a pay-per-view program on TVs connected to
up to six receivers, you must order the program for each receiver
but you only pay for the program once.
/FAX
ATA
You do not have to do anything. You can always use your telephone
line, because the receiver automatically hangs up if it finds the line is
busy.
Install a DSL filter between the receiver and the telephone wall jack.
Hang up, and then pick up the telephone again to get a dial tone.
Resend the FAX or modem transmission.
Have the sender resend the FAX or modem transmission.
What to Do
What to Do