Dish Network 311 User Manual page 28

Chapter 2
Parts of the System
Page 22
2. Connect a cable between the TV S
the TV input. Peel off the white sticker and place it on the cable close to the
connection.
TV S O
ET UT
Note: Connecting your television directly to the audio/video output of your
receiver assures a more vivid picture and enhances your viewing enjoyment.
3. Optionally, connect a cable between the TV S
receiver and the input to the VCR. Connect another cable between the VCR
output and TV input. Peel off the white sticker and place it on the cable
close to the TV S
ET
4. Set the C 3-4 switch on the back of the receiver to the channel (3 or
HANNEL
4) that you use to watch TV.
5. Plug in and turn on your receiver and TV.
6. Tune the TV to the same channel you set in step 3. If you do not have a clear
picture, change the TV and C
channel (for example, if the TV and receiver are on channel 3, change both
to channel 4).
7. Program the remote to control the TV (and VCR) as described on page 11.
screen is not displayed on the TV, press MENU-6-1-1 on
8. If the
Point Dish
the remote control.
9. Select
Check Switch
10. The receiver begins performing the
the
Install Summary
11. Make sure that the information on the
your system correctly and shows all transponders for all satellites in your
system.
12. Select to go to the
OK
13. From the
Point Dish
14. Wait while the receiver acquires a signal and the Program Guide downloads.
Once the Program Guide has downloaded, you should be viewing your
satellite programming.
on the back of the receiver and
O
ET UT
connection.
O
UT
3-4 switch settings to the other
HANNEL
. When an attention screen displays, select
Check Switch
screen displays.
Install Summary
screen.
Point Dish
screen, press VIEW TV.
on the back of the
O
ET UT
.
Test
tests. When it is finished,
screen identifies