Control Other Devices With The Remote - Dish Network 311 User Manual

R B
ECOVER UTTON
Follow these instructions if you accidentally change the channel or video
input on your TV and have a snowy, blue, or black screen. When you press
the RECOVER button as described below, the remote control sends
commands to your TV to change channels or video inputs to try to get you
back to watching satellite programming. This procedures works only if you
have accidentally changed the channel or video input and does not recover
lost satellite signal (See Chapter 4, Reference for troubleshooting
information). The Recover button only works if the remote control has been
set up to control the TV and/or VCR/DVD/BD.
: You may need to press the RECOVER button up to 30 times to
Note
recover your satellite TV video.
1. Press and hold the RECOVER button until all four mode buttons light,
and then release the button. The SAT mode button flashes twice and
then all four mode buttons flash three times.
2. Press the RECOVER button. The TV mode button flashes once and
then all four mode buttons flash once.
: Recover first tries to tune your TV to channel 3, then channel 4,
Note
and then other video inputs.
3. If you see the
System Info - One
close the screen. You have recovered your satellite video.
4. If you do not see the
until you have recovered your satellite video.
: Press any remote control button other than the RECOVER button
Note
to end this procedure.
C O
ONTROL THER
R C M
EMOTE ONTROL
You can set the remote to four different modes to control the receiver or
other devices. This section explains how to set up the remote to control a
device, such as a satellite TV receiver, a TV, a VCR, a DVD player, a BD
player, a tuner, or an amplifier.
To set the remote to the right mode for a device, use the remote control's
mode buttons, SAT (satellite receiver), TV, VCR (for a VCR, DVD, or a
BD player), and AUX ("auxiliary," for a DVD player, or an audio
amplifier). To change the mode, press the button for the device you want the
remote to control. The mode button flashes once to show you've set the
remote to that mode.
screen, press the SELECT button to
System Info - One
D
EVICES WITH THE
ODES

Control Other Devices with the Remote

screen, repeat steps 2 and 3
R
EMOTE
Tip: You can
program the
remote that
came with your
receiver to
control as many
as three other
devices.
Page 11