Rheem 871 Series Owner's Manual And Installation Instructions page 32

TEMPERATURE CONTROL – DELUXE
BATH FILL MODE
The Bath Fill mode is designed to allow the water heater to deliver a selected volume of water at a selected
temperature. The Bath Fill mode commences when the BATH FILL button is on and a hot tap is opened.
When the set volume has been delivered, the water flow from the water heater ceases and heating stops. It
is also useful for controlling the water volume used by a shower or other application.
Note: The bath level should be monitored periodically while this function is in use to avoid the possibility of
the bath overflowing. The Bath Fill mode should be used with caution until you are familiar with its operation.
Warning: Baths should not be left unattended whenever young children are present. After using the
bath fill function, check the water temperature before entering a bath, to ensure it is suitable and will not
cause scald injury.
The Bath Fill mode can be set and turned off at any of the Deluxe controllers. Refer to the
Bath Fill Mode – Brief Guide
This guide provides a brief instruction on the operating sequence of the bath fill function. It is recommended
to read the explanatory notes and become familiar with each step in the bath fill function. Refer to
Mode – Explanatory Notes"
To operate the Bath Fill Mode:
Turn off all Deluxe controllers
1.
It is advised to turn off all Deluxe controller(s) before
activating the Bath Fill mode.
Refer to the notes on the
on page 30.
Pull down the front panel on the Deluxe controller.
2.
The BATH FILL VOLUME and BATH FILL TEMPERATURE
up ( ) and down ( ) buttons will be exposed.
3. Set the Bath Fill temperature
Press the BATH FILL TEMPERATURE
the BATH FILL TEMPERATURE
select the desired bath fill temperature.
Refer to "Temperature Adjustment – Deluxe Controllers"
on page 27.
The selected temperature setting will be displayed on all
Deluxe controllers.
Set the bath fill water volume
4.
Press the BATH FILL VOLUME
BATH FILL VOLUME
desired bath fill water volume. Each press will change
the water volume setting by 10 litres.
Pressing the BATH FILL VOLUME
BATH FILL VOLUME
scroll the water volume setting.
A maximum volume of 990 litres and a minimum volume
of 10 litres can be set. The volume changes in 10 litre
increments.
The selected bath fill water volume will be displayed and
the bath fill indicator light will glow on all Deluxe
controllers.
on page 34.
Bathroom Deluxe controllers
(down button) to
(up button) or the
(down button) to select the
(up button) or
(down button) continuously will
(up button) or
"caution, bath fill water volume has
been increased, bath may overflow"
32
notes on page 38.
ACTIVE
°C
8 8 8 8 5 5
BATH (l)
BATH FILL ON/OFF
BATH FILL BATH FILL
VOLUME TEMPERATURE
B1
ACTIVE
°C
1 2 0 4 0
BATH (l)
BATH FILL ON/OFF
"hot water temperature has
been increased"
or
"hot water temperature has
been decreased"
ACTIVE
°C
1 2 0 4 0
BATH (l)
BATH FILL ON/OFF
or
"bath fill water volume has been
decreased"
"Bath Fill