Install The Log Assembly - Heatilator Gas Fireplace GDCL4136I Owner's Manual

F. Install the Log Assembly
CAUTION: DO NOT reposition logs that have been
factory installed! Follow these instructions to position
the logs that were packaged separately.
Figure 1. Log Assembly Location
CAUTION!
Logs are fragile! Carefully remove the logs and cardboard tray from the inside of the fi replace. See Figure
Remove the microfoam and inspect the logs for damage. Inspect the four factory installed logs for damage. Locate the
pilot in order to verify your position in relation to the appliance. See Figure 2.
Models: GDST4336I, GDFL4136I, GDCL4136I, GBST4336I, GBFL4136I
(For Model GDCR4136I, see next page.)
Figure 3. Placement of Log #1
STEP 1. Log #1 (SRV2129-704):
Log A highlighted in Figure 3. The Y-shaped end of Log #1 will rest on the smooth area of Log B as shown in Figure 4.
60 Heatilator • GDST4336I, GDFL4136I, GDCR4136I, GDCL4136I • 2129-900 Rev. F • 11/08
PILOT PILOT
1 1
A A
Place Log #1 on Log A. The end and bottom of Log #1 fi t into the indentation on
Log Set Assembly: LOGS-2129
Models: GDST4336I, GDFL4136I, GDCL4136I,
GDCR4136I, GBST4336I, GBFL4136I
3 3
Log Set Components
PILOT PILOT
A A
B B
Figure 2. Factory Installed Logs and Pilot Position
Figure 4. Placement of Log #1
2 2
1 1
D D
1 1
B B
HUMP HUMP
1 1
C C
C C
PILOT PILOT
A A
2129-935