Heatilator Gas Fireplace GDCL4136I Owner's Manual page 61

C C
2 2
2 2
Figure 5. Placement of Log #2
STEP 2. Log #2 (SRV2129-705):
#2 on the indentation on Log C. Log #2 will rest on the tip of Log B. Slide the bottom of Log #2 up to the edge of the burner
as shown in Figure 6.
Figure 7. Placement of Log #3
STEP 3. Log #3 (SRV2129-707):
Log 3 should extend beyond Log #2 by one inch.
Model: GDCR4136I
A A
B B
Figure 9. Placement of Log #1
STEP 1. Log #1 (SRV2129-704):
Log A highlighted in Figure 9. The Y-shaped end of Log #1 will rest on the smooth area of Log B as shown in Figure 10.
Heatilator • GDST4336I, GDFL4136I, GDCR4136I, GDCL4136I • 2129-900 Rev. F • 11/08
PILOT PILOT
B B
D D
Locate portion of Log #2 that is highlighted in Figure 5. Place that portion of Log
PILOT PILOT
3 3
Place Log #3 so that it rests on the indentations located on Log #2 and Log D.
1 1
Place Log #1 on Log A. The end and bottom of Log #1 fi t into the indentation on
2 2
BURNER EDGE BURNER EDGE
Figure 6. Placement of Log #2
1 in. 1 in.
2 2
Figure 8. Placement of Log #3
1 1
A A
B B
Figure 10. Placement of Log #1
PILOT PILOT
B B
PILOT PILOT
D D
61