Measuring At One Listening Position (Single Measure) - Yamaha RX-A1030 Owner's Manual

1 2 3 4 5 6 7 8 9
Automatic speaker setup
SOURCE SOURCE RECEIVER RECEIVER
AV AV
1 1 2 2 3 3 4 4
5 5 6 6 7 7 V-AUX V-AUX
AUDIO AUDIO
1 1 2 2 3 3 4 4
PHONO PHONO MULTI MULTI USB USB NET NET
TUNER TUNER
PARTY PARTY HDMI OUT HDMI OUT
MAIN MAIN ZONE 2 ZONE 2
SCENE SCENE
1 1 2 2 3 3 4 4
BD/DVD BD/DVD TV TV NET NET RADIO RADIO
PROGRAM PROGRAM MUTE MUTE VOLUME VOLUME
TOP MENU TOP MENU POP-UP/MENU POP-UP/MENU
ON ON
OPTION OPTION
SCREEN SCREEN
Cursor keys
ENTER
ENTER
RETURN
RETURN DISPLAY DISPLAY
BAND BAND
MODE MODE
TUNING TUNING PRESET PRESET
SUR. DECODE SUR. DECODE STRAIGHT STRAIGHT
MOVIE MOVIE MUSIC MUSIC
ENHANCER ENHANCER PURE DIRECT PURE DIRECT
INFO INFO SLEEP SLEEP
1 1 2 2 3 3 4 4
5 5 6 6 7 8 8
MEMORY MEMORY
9 9 0 0 10 10 ENT ENT
TV TV
INPUT INPUT
TV VOL TV VOL TV CH TV CH
MUTE MUTE CODE SET CODE SET
Measuring at one listening position
(single measure)
When "Multi Position" is set to "No", follow the procedure below for
measurement.
• Do not stand between the speakers and the YPAO microphone during the
measurement process (about 3 minutes).
• Move to the corner of the room or leave the room.
1
To start the measurement, use the cursor keys to
select "Measure" and press ENTER.
The measurement will start in 10 seconds. Press ENTER
again to start the measurement immediately.
• To cancel the measurement temporarily, press RETURN.
The following screen appears on the TV when the
measurement finishes.
• If any error message (such as E-1) or warning message (such as W-1)
appears, see "Error messages" (p.47) or "Warning messages" (p.48).
• To check the measurement results, select "Result". For details, see
"Checking the measurement results" (p.45).
2
Use the cursor keys to select "Save/Cancel" and
press ENTER.
3
To save the measurement results, use the cursor
keys (e/r) to select "SAVE" and press ENTER.
The adjusted speaker settings are applied.
• To finish the measurement without saving the result, select "CANCEL".
4
Disconnect the YPAO microphone from the unit.
This completes optimization of the speaker settings.
Caution
• The YPAO microphone is sensitive to heat, so should not be placed anywhere
where it could be exposed to direct sunlight or high temperatures (such as on
top of AV equipment).
PREPARATIONS ➤ Optimizing the speaker settings automatically (YPAO)
43
En