Yamaha RX-A1030 Owner's Manual page 105

❑ Extra Bass
Sets the speakers to produce the front channel low-frequency components.
Settings
Depending on the size of the front speakers, either the subwoofer or
Off (default)
front speakers produce the front channel low-frequency components.
Both the front speakers and subwoofer produce the front channel
On
low-frequency components.
• This setting is not available when "Subwoofer" is set to "None", or when "Front" is set to "Small".
❑ Bass Cross Over
Sets the lower limit of the low-frequency components that can be output from a speaker
whose size is set to "Small". A frequency sound lower than the specified value will be
produced from the subwoofer or front speakers.
Settings
40 Hz, 60 Hz, 80 Hz (default), 90 Hz, 100 Hz, 110 Hz, 120 Hz, 160 Hz, 200 Hz
• If the volume and crossover frequency are adjustable on your subwoofer, set the volume to half and
crossover frequency to maximum.
■
Distance
Sets the distance between each speaker and listening position so that sounds from the
speakers reach the listening position at the same time. First, select the unit of distance
from "Meter" or "Feet".
Choices
Front L, Front R, Center, Surround L, Surround R, Surround Back L, Surround Back R,
Front Presence L, Front Presence R, Subwoofer
Setting range
0.30 m to 24.00 m (1.0 ft to 80.0 ft), *0.05 m (0.2 ft) increments
Default
3.00 m (10.0 ft)
■
Level
Adjusts the volume of each speaker.
Choices
Front L, Front R, Center, Surround L, Surround R, Surround Back L, Surround Back R,
Front Presence L, Front Presence R, Subwoofer
Setting range
-10.0 dB to +10.0 dB (0.5 dB increments)
Default
0.0 dB
■
Parametric EQ
Adjusts the tone with an equalizer.
Settings
Select this option when you want to adjust the equalizer manually.
Manual
For details, see "Manual equalizer adjustment".
YPAO:Flat Adjusts individual speakers to achieve the same characteristics.
Adjusts individual speakers to achieve the same characteristics as
YPAO:Front
the front speakers.
YPAO:Natural Adjusts all speakers to achieve a natural sound.
Through Does not use the equalizer.
• "YPAO:Flat", "YPAO:Front", and "YPAO:Natural" are available only when the measurement results of "Auto
Setup" have already been saved (p.41). Press ENTER again to view the measurement results.
■
Manual equalizer adjustment
1
Set "Parametric EQ" to "Manual" and press ENTER.
2
Press ENTER again to enter the edit screen.
3
Use the cursor keys to select a speaker and press ENTER.
• To restore the default settings for all speakers, select "PEQ Data Clear" and then "OK".
• To copy the parametric equalizer values acquired with "Auto Setup" (p.41) to the "Manual" fields for
fine adjustment, select "PEQ Data Copy" and then an equalizer type.
CONFIGURATIONS ➤ Configuring various functions (Setup menu)
105
En