Updating The Unit's Firmware Via The Network - Yamaha RX-A1030 Owner's Manual

SOURCE SOURCE RECEIVER RECEIVER
AV AV
1 1 2 2 3 3 4 4
New firmware that provides additional features or product
5 5 6 6 7 7 V-AUX V-AUX
improvements will be released as needed. If the unit is connected
AUDIO AUDIO
1 1 2 2 3 3 4 4 to the Internet, you can download the firmware via the network and
update it.
PHONO PHONO MULTI MULTI USB USB NET NET
TUNER TUNER
PARTY PARTY HDMI OUT HDMI OUT
MAIN MAIN ZONE 2 ZONE 2
SCENE SCENE
1 1 2 2 3 3 4 4
BD/DVD BD/DVD TV TV NET NET RADIO RADIO
PROGRAM PROGRAM MUTE MUTE VOLUME VOLUME
TOP MENU TOP MENU POP-UP/MENU POP-UP/MENU
ON ON
OPTION OPTION
SCREEN SCREEN
Cursor keys
ENTER
• You can also update the firmware using the USB memory device from the
ENTER
RETURN RETURN DISPLAY DISPLAY
BAND BAND A firmware update is available if the following message is displayed
MODE MODE
after ON SCREEN is pressed.
TUNING TUNING PRESET PRESET
SUR. DECODE SUR. DECODE STRAIGHT STRAIGHT
MOVIE MOVIE MUSIC MUSIC
ENHANCER ENHANCER PURE DIRECT PURE DIRECT
INFO INFO SLEEP SLEEP
1 1 2 2 3 3 4 4
5 5 6 6 7 8 8
MEMORY MEMORY
9 9 0 0 10 10 ENT ENT
TV TV
INPUT INPUT
TV VOL TV VOL TV CH TV CH
MUTE MUTE CODE SET CODE SET
1
2

Updating the unit's firmware via the network

Note
• Do not operate the unit or disconnect the power cable or network cable during
firmware update. Firmware update takes about 20 minutes or more
(depending on your Internet connection speed).
• If the Internet connection speed is slow or if the unit is connected to the
wireless network via a wireless network adapter, network update may not be
possible depending on the condition of the wireless connection. In this case,
try the firmware update later or use the USB memory device (p.122).
"ADVANCED SETUP" menu (p.122).
Read the on-screen description.
To start the firmware update, use the cursor keys to
select "START" and press ENTER.
The on-screen display turns off.
3
If "UPDATE SUCCESS PLEASE POWER OFF!"
appears on the front display, press MAIN ZONE z
on the front panel.
The firmware update is complete.
• If you want to update the firmware later, select "CLOSE" in Step 2. "!" (exclamation
mark) appears at the upper right of the "Information" and "System" icons, and a
message will be displayed in the "System" screen (p.118). You can update the
unit's firmware by pressing ENTER in the "System" screen.
Information
icon
Message
System Icon
CONFIGURATIONS ➤ Updating the unit's firmware via the network
128
En