Four Slot Ethernet Cradle; Setup; Ethernet Cradle Drivers - Symbol MC3000 Integrator Manual

Four Slot Ethernet Cradle

This section describes how to set up and use a Four Slot Ethernet cradle with the mobile computer.
The Four Slot Ethernet cradle:
• Provides 5.4 VDC power for operating the mobile computer.
• Connects the mobile computer (up to four) to an Ethernet network.
You cannot ActiveSync using the Four Slot Ethernet cradle. To ActiveSync with a host computer, use the SIngle Slot Serial/USB cradle.
Use only a Symbol approved power supply output rated 12 VDC and minimum 9 A. Use of an alternative power
supply will void the product warranty and may cause product damage. See the MC3000 User Guide for the
power supply regulatory compliance statement.

Setup

Connect the Ethernet cradle (Ethernet port 1) to an Ethernet hub or a port on the host device. Connect the Ethernet cradle (power port)
to a Symbol approved power supply.
Ethernet Switch
Connection

Ethernet Cradle Drivers

The Ethernet cradle drivers are pre-installed on the MC3000 and initiate automatically when the MC3000 is placed in a properly
connected Four Slot Ethernet cradle.
When the mobile computer is inserted into the Four Slot Ethernet cradle, the LAN icon indicates that the mobile computer is
connected to a network.
Power Port
Ethernet Port 1
Figure 2-5. Four Slot Ethernet Cradle Connection
Accessories 2-9