Opening And Closing The Power Liftgate - Ford EXPLORER 2014 Owner's Manual

Opening and Closing the Power Liftgate

Note: You can reverse the liftgate movement direction with a second
press of the instrument panel button, or the control button on the
liftgate, or a second double press of the transmitter button.
The liftgate will only operate with the transmission in P.
A chime will sound three times as the liftgate begins to power close.
A single chime indicates a problem with the close request, caused by:
• the ignition is on and the transmission is not in P; or
• the battery voltage is below the minimum operating voltage; or
• the vehicle speed is at or above 3 mph (5 km/h).
If the liftgate reverses and starts to close after an open request, a fast
continuous chime indicates excessive load on the gate or a possible strut
failure. Have your vehicle checked by an authorized dealer if you still
have a fast chime after you remove the load.
To open or close from the instrument panel: Press the
instrument panel button.
To open or close with the remote control: Press the remote
control button twice within three seconds.
2. Press the control button located in the top of the liftgate pull-cup
handle.
Note: Allow the power system to open the liftgate after pressing the
control. Manually pushing or pulling the liftgate may activate the
system's obstacle detection feature and stop the power operation.
2014 Explorer (exp)
Owners Guide gf, 3rd Printing, September 2013
USA (fus)
Locks
To open with the outside liftgate
control button:
1. Unlock the liftgate with the remote
control or power door unlock control.
If the intelligent access transmitter is
within 3 feet (1 meter) of the liftgate,
the liftgate will unlock when you
press the liftgate release button.
83