Replacing Front Fog Lamp Bulbs; Replacing Turn/Backup Lamp Bulbs - Ford EXPLORER 2014 Owner's Manual

Replacing front fog lamp bulbs

1. Make sure the headlamp switch is off.
Reverse steps to reinstall bulb(s).

Replacing turn/backup lamp bulbs

The turn/backup lamp bulbs are located in the same area of the tail lamp
assembly, one below the other. Follow the same steps to replace these
bulbs:
1. Make sure the headlamp switch is in the off
position, then open the liftgate to expose the lamp
assembly bolts.
2. Remove the two bolt covers using a standard flattip
screwdriver.
3. Remove the two bolts from the lamp assembly.
4. Carefully remove the lamp assembly away from the
vehicle by pulling the assembly straight out to expose
the bulb socket.
6. Pull bulb straight out of socket.
7. Install the new bulb in reverse order.
2014 Explorer (exp)
Owners Guide gf, 3rd Printing, September 2013
USA (fus)
Maintenance
1. Make sure that the fog lamp switch
is in the off position.
2. Remove the bulb socket
from the fog lamp by turning it
counterclockwise.
3. Disconnect the electrical
connector.
5. Remove the bulb socket from
the lamp assembly by turning it
counterclockwise.
343