Connecting To The Internet; Creating A Modem Connection To An Isp - Intermec 70 User Manual

Model 70 Pocket PC 2002 User's Guide
To receive information
1. Align the IR ports so that they are unobstructed and within a close range.
2. Have the owner of the other device send information to you. Your Model 70 will

Connecting to the Internet

You can connect to your ISP and use the connection to send and receive e-mail
messages and view Web or WAP pages. You can connect to the Internet in one of two
ways:
•
•

Creating a Modem Connection to an ISP

1. Obtain the following information from your ISP: ISP dial-up access telephone
2. Install a modem card, or use a NULL modem cable and appropriate adapters to
3. Tap
4. In the Modem tab, tap New.
5. Enter a name for the connection, such as "ISP Connection."
6. In the Select a modem list, select your modem type. If your modem type does not
7. You should not need to change any settings in Advanced. Most ISPs now use a
8. Enter the access phone number and tap Next.
9. Select other desired options and tap Finish.
10. On the Dialing Locations tab, specify your current location and phone type (most
6-4
automatically receive it.
Create a modem connection. If this is the method you want to use, see "Creating a
Modem Connection to an ISP" in the next section.
Use an Ethernet card and a net tap to connect to the network. If this is the method
you want to use, see "Creating an Ethernet Connection to an ISP" later in this
section.
number, user name, password, and TCP/IP settings. Some ISPs require information
in front of the user name, such as MSN/username.
connect an external modem to your Model 70 through the serial port.
and then Settings. In the Connections tab, tap Connections. Under The
Internet settings, select Internet Settings and tap Modify.
appear, try re-inserting the modem card. If you are using an external modem that is
connected to your Model 70 with a cable, select Hayes Compatible on COM1.
dynamically-assigned address. If the ISP you are connecting to does not use a
dynamically-assigned address, tap Advanced and then the TCP/IP tab and enter the
address. When finished, tap ok and then Next.
phone lines are tone). These settings will apply to all connections you create.