Maxtor ATLAS 10K IV User Manual page 93

Table 5-34
Field
Code Set
Association
Identifier Type
5.11.2.6 Firmware Revision Page (C0h)
The Firmware Revision page reflects the current firmware revision and date and time
when it was built. The Firmware Revision Page is described in Table 5-35.
Bit
7
Byte
0
1
2
3
4 - 19
20 - 39
Device Identification Page - Field Description
This field specifies the code set used for the Identifier field. Applicable values are:
Value Description
0h Reserved
1h The Identifier field contains binary values
2h The Identifier field contains ASCII graphic codes (code values 20h through 7Eh)
3h – Fh Reserved
This field specifies the entity with which the Identifier field is associated. Applicable
values are:
Value Description
0h The Identifier field is associated with the addressed physical or logical device.
1h The identifier field is associated with the port that received the request.
2h – 3h Reserved
This field specifies the format and assignment authority for the identifier. Values in
this field are:
Value Description
0h No assignment authority was used; there is no guarantee that the identifier is glo-
bally unique (vendor-specific).
1h The first 8 bytes of the Identifier field represent the Vendor ID.
2h The Identifier field contains an IEEE Extended Unique Identifier, 64-bit (EUI-64).
The Identifier Length field (Byte 7) is set to 8.
3h Not applicable; for Fibre Channel devices.
4h Not applicable; if the Association value = 1h, the value of the Identifier contains a
4-byte, binary number that identifies the port relative to the other ports in the device.
5h - Fh Reserved
Firmware Revision Page-Data Format
Table 5-35
6 5
Peripheral Qualifier
= 0
Full Firmware Version Blank Fill (e.g., "T382 ")
Build Date and Time Blank Fill (e.g., "Jan 19 1999 07:18:15")
Definition
4 3 2
Peripheral Device Type = 0
(Direct Access Device)
Page Code (C0h)
Reserved
Page Length = 24h
Maxtor Atlas 10K IV
SCSI Description
1 0
5-27