Regulatory Statements - Maxtor ATLAS 10K IV User Manual

Regulatory Statements

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC
rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. Any
modifications of this device - unless expressly approved by the manufacturer - can void the user's authority to operate this equip-
ment under Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful
interference and (2) This device must accept any interference that may cause undesirable operation.
This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. Howerver, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the fol-
lowing measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
NOTE: Additional information on the need to interconnect the device with shielded (data) cables or the need for special devices,
such as ferrite beads on cables, is required if such means of interference suppression was used in the qualification test for the
device. This information will vary from device to device and needs to be obtained from the EMC group or product manager.
This Class B digital apparatus complies with Canadian ICES-003.