Maxtor ATLAS 10K IV User Manual page 186

SCSI Description
Sense
Key
0x05
Illegal Request
0x06
Unit Attn
5-120 Maxtor Atlas 10K IV
Sense Sense
Code Qualifier
0x1A 0x00 Parameter list length error
0x20 0x00 Invalid command.
0x20 0xFE ETM can't run with motor spinning
0x20 0xFF Selfscan code not loaded or bad
0x21 0x00 Invalid LBA
0x24 0x00 Invalid bits set in CDB
0x25 0x00 Invalid LUN specified
0x26 0x00 Invalid fields in parameters
0x26 0x02 Bad fields in parameters
0x26 0x04 Invalid release of persistent reservation
0x26 0x80 Invalid Code image checksum failed
0x26 0x81 Incorrect product code loaded
0x26 0x82 Invalid Offset for image
0x26 0x83 Invalid ASIC for this code load
0x26 0x84 Invalid channel for this code load
0x2C 0x00 Invalid command sequence
0x3D 0x00 Invalid bit set in identify
message
0x0B 0x01 SMART overtemperature trip
0x28 0x00 Not Ready to Ready transition
0x29 0x01 Power-On-Reset occurred
0x29 0x02 SCSI bus reset occurred
0x29 0x03 Bus device reset message
0x29 0x04 Recovered from bug check
0x29 0x05 Bus mode changed to single ended
0x29 0x06 Bus mode changed to LVDS
0x29 0x86 Reset after too many ACK's
0x2A 0x01 Mode parameters were changed
0x2A 0x02 Log parameters were changed
0x2A 0x03 Persistent Reservations were cleared
0x2A 0x04 Persistent Reservations were released
0x2A 0x05 Persistent Reservations were cleared
0x2f 0x00 Cmd Queue cleared by another initiator
0x3f 0x01 Microcode has been changed
0x3f 0x05 Device Identifier changed
0x5C 0x01 Spindle synced
0x5C 0x02 Spindle not synced
0x5D 0x00 Smart triggered
0x5D 0x01 Smart triggered due to Write TA Factor
0x5D 0x02 Smart triggered due to Write Err Factor
Meaning