Write Buffer Command (3Bh); Table 5-212 Write Buffer Command Descriptor Block-Data Format - Maxtor ATLAS 10K IV User Manual

SCSI Description
5.48

WRITE BUFFER Command (3Bh)

The WRITE BUFFER and the READ BUFFER commands allow the initiator to gain
access to the data storage areas within the drive controller. These commands are used
to check the integrity of the buffer-initiator data path independent of the storage
medium, typically for fault isolation. The commands can be used to verify the
caching policies of the controller or other kinds of debug work. In addition, the
WRITE BUFFER command supports controller microcode downloads. The data
format and field descriptions are shown in Table 5-212 and Table 5-213 respectively.
Both the READ BUFFER and WRITE BUFFER commands have a Buffer ID and a
Buffer Offset data field defined in their Command Descriptor Block. In combined
Header and Data Mode, if both are set to 0, reference is made to a single, 512-byte
buffer set aside in the controller's data memory, independent of cache. This allows an
initiator to verify the data path from the controller's data memory to the initiator
without affecting the drive's internal data caches.
Table 5-212
Bit
Byte
0
1
2
3 - 5
6 - 8
9
5-140 Maxtor Atlas 10K IV
WRITE BUFFER Command Descriptor Block-Data Format
7 6 5
Reserved
4 3
Operation Code (3Bh)
Buffer ID
Buffer Offset
Parameter List Length
Control
2 1 0
Mode