Figure 3-4 Pin Locations On Sca-2 Connector - Maxtor ATLAS 10K IV User Manual

3.4.3.2 SCSI ID for SCA-2 Versions
Each SCSI device on the bus must have a unique SCSI ID number assigned to it.
The drive can be configured for SCSI ID numbers that range from 0 through 15.
Configure the SCSI ID by providing the proper open or ground signal inputs to the
referenced pins of the drive's 80-pin new version SCA-2 connector (Figure 3-4).
Refer to Table 3-2 for SCSI ID pin assignments.
Note: Refer to your system or SCSI controller documentation for spe-
cific recommendations about assigning SCSI ID numbers for
your specific system.
Pin Locations on SCA-2 Connector
Figure 3-4
Installation
Maxtor Atlas 10K IV 3-11