Using M5155 and M5163
Configuring Universal paper settings
The Universal paper size is a user‑defined setting that lets you print on paper sizes that are not preset in the printer
menus.
Notes:
•
The smallest supported Universal size is 70 x 127 mm (2.76 x 5 inches) for one‑sided printing and
105 x 148 mm (4.13 x 5.83 inches) for two‑sided (duplex) printing.
•
The largest supported Universal size is 216 x 356 mm (8.5 x 14 inches) for one‑sided and two‑sided printing.
•
When printing on paper less than 210 mm (8.3 inches) wide, the printer prints at a reduced speed to prevent
damage to the fuser.
1
From the home screen, navigate to:
> Paper Menu > Universal Setup > Units of Measure > select a unit of measure
2
Touch Portrait Width or Portrait Height.
3
Select the width or height, and then touch
Loading the 250‑ or 550‑sheet tray
CAUTION—POTENTIAL INJURY: To reduce the risk of equipment instability, load each tray separately. Keep all
other trays closed until needed.
1
Pull out the tray.
Notes:
•
When loading Folio‑, legal‑, or Oficio‑size paper, lift the tray slightly and pull it out.
•
Do not remove trays while a job prints or while Busy appears on the display. Doing so may cause a jam.
.
59