Display Unit Test - Furuno DS-60 Operator's Manual

6. MAINTENANCE, TROUBLESHOOTING
6.5.2

Display unit test

Do the display unit test to check the display unit for correct operation.
1. Press the MENU/ESC key to open the menu.
2. Select [TESTS] then press the ENT key.
3. Select [Display Unit TEST].
4. Press the ENT key, and the results of the display unit test appear.
STARTER PROG No.
BOOTER PROG No. 6652001-xx.xx
MAIN PROG No.
REMOTE PROG No. 2651009-xx.xx
DIMMER PROG No. 2651009-xx.xx
Description of test results for the Display Unit DS-600
• The results of the ROM and RAM check are shown as OK (normal) or NG (No
Good). For any NG, reset the power and try the test again. If the NG condition
continues, contact your dealer for instruction.
• "SENSOR", "REMOTE-DAISY" show the results of the serial loopback test,
which requires a special test connector. OK for normal, no indication if there is
error.
• "LCD Time" shows how many hours the LCD has been powered, up to a max-
imum of 999,999 hours.
• "BRILL" shows the current LCD brilliance setting. Press
liance control circuit. Check if the indication and brilliance level agree.
• "+5V" shows the voltage of the +5V circuit.
• The program number of the starter program, booter program, main program, re-
mote program and dimmer program are shown. (The program no. indication is
blank where no equipment is not connected.)
The rectangles on the screen are for testing the controls of the Display Unit,
Remote Controller and Dimmer Controller. Press any key except the PWR and
DISP keys. The key's on-screen rectangle fills in red if the key is normal. Press
the key again and the red fill is removed.
5. To quit the self test, press the MENU/ESC key three times.
6-8
-XXXX
OK
OK
8
5.0
6652000-xx.xx
6652002-xx.xx
, to check the bril-