This chapter describes how to configure the WAN using menu 2.
22.1 Introduction to WAN
This chapter explains how to configure settings for your WAN port.
22.2 WAN Setup
From the main menu, enter 2 to open menu 2.
Figure 124 Menu 2 WAN Setup
The following table describes the fields in this menu.
Table 86 Menu 2 WAN Setup
FIELD
MAC Address
Assigned By
IP Address
When you have completed this menu, press [ENTER] at the prompt "Press ENTER to Confirm..." to
save your configuration, or press [ESC] at any time to cancel.
Chapter 22 Menu 2 WAN Setup
C
Menu 2 WAN Setup
Menu 2 - WAN Setup
MAC Address:
Assigned By= Factory default
IP Address= N/A
DESCRIPTION
Press [SPACE BAR] and then [ENTER] to choose one of two methods to assign a
MAC Address. Choose Factory Default to select the factory assigned default
MAC Address. Choose IP address attached on LAN to use the MAC Address of
that computer whose IP you give in the following field.
This field is applicable only if you choose the IP address attached on LAN
method in the Assigned By field. Enter the IP address of the computer on the
LAN whose MAC you are cloning.
ZyAIR G-2000 Plus User's Guide
H A P T E R
2 2
262