Table of Contents
Advertisement
ZyAIR G-2000 Plus User's Guide
Table 104 Menu 15.1.1.1 Editing/Configuring an Individual Rule in a Set
FIELD
End
When you have completed this menu, press [ENTER] at the prompt "Press ENTER to confirm or ESC
to cancel" to save your configuration or press [ESC] to cancel and go back to the previous screen.
28.4 Configuring a Server behind NAT
Follow these steps to configure a server behind NAT:
1 Enter 15 in the main menu to go to Menu 15 - NAT Setup.
2 Enter 2 to display Menu 15.2 - NAT Server Setup as shown next.
Figure 153 Menu 15.2.1 NAT Server Setup
3 Enter a port number in an unused Start Port No field. To forward only one port, enter it
again in the End Port No field. To specify a range of ports, enter the last port to be
forwarded in the End Port No field.
4 Enter the inside IP address of the server in the IP Address field. In the following figure,
you have a computer acting as an FTP, Telnet and SMTP server (ports 21, 23 and 25) at
192.168.1.33.
5 Press [ENTER] at the "Press ENTER to confirm ..." prompt to save your configuration
after you define all the servers or press [ESC] at any time to cancel.
You assign the private network IP addresses. The NAT network appears as a single host on the
Internet. A is the FTP/Telnet/SMTP server.
301
DESCRIPTION
This is the ending inside global IP address (IGA). This field is N/A for One-to-One,
Many-to-One and Server types.
Menu 15.2 - NAT Server Setup
Rule
Start Port No.
---------------------------------------------------
1.
Default
2.
21
3.
0
4.
0
5.
0
6.
0
7.
0
8.
0
9.
0
10.
0
11.
0
12.
0
Press ENTER to Confirm or ESC to Cancel:
End Port No.
Default
25
0
0
0
0
0
0
0
0
0
0
Chapter 28 Network Address Translation (NAT)
IP Address
0.0.0.0
192.168.1.33
0.0.0.0
0.0.0.0
0.0.0.0
0.0.0.0
0.0.0.0
0.0.0.0
0.0.0.0
0.0.0.0
0.0.0.0
0.0.0.0
Advertisement
Table of Contents
Troubleshooting
