Figure 64 Static Route: Edit; Table 49 Static Route: Edit - ZyXEL Communications ZyAIR G-2000 PLUS User Manual

Figure 64 Static Route: Edit

The following table describes the labels in this screen.

Table 49 Static Route: Edit

LABEL
Route Name
Active
Destination IP
Address
IP Subnet Mask
Gateway IP
Address
Metric
Private
Apply
Cancel
Chapter 11 Static Route Screens
DESCRIPTION
Enter the name of the IP static route. Leave this field blank to delete this static route.
This field allows you to activate/deactivate this static route.
This parameter specifies the IP network address of the final destination. Routing is
always based on network number. If you need to specify a route to a single host, use
a subnet mask of 255.255.255.255 in the subnet mask field to force the network
number to be identical to the host ID.
Enter the IP subnet mask here.
Enter the IP address of the gateway. The gateway is an immediate neighbor of your
ZyAIR that will forward the packet to the destination. On the LAN, the gateway must
be a router on the same segment as your ZyAIR; over the WAN, the gateway must
be the IP address of one of the Remote Nodes.
Metric represents the "cost" of transmission for routing purposes. IP routing uses
hop count as the measurement of cost, with a minimum of 1 for directly connected
networks. Enter a number that approximates the cost for this link. The number need
not be precise, but it must be between 1 and 15. In practice, 2 or 3 is usually a good
number.
This parameter determines if the ZyAIR will include this route to a remote node in its
RIP broadcasts.
Select this check box to keep this route private and not included in RIP broadcasts.
Clear this checkbox to propagate this route to other hosts through RIP broadcasts.
Click Apply to save your changes back to the ZyAIR.
Click Cancel to return to the previous screen and not save your changes.
ZyAIR G-2000 Plus User's Guide
154