Konica Minolta IP-011 User Manual page 58

Chapter 3 Printer Driver
In addition, when Staple is specified, you can't select Alternate.
You can't staple at two positions for the paper of B5R or smaller.
Stapling is performed in accordance with orientations as follows:
T
Timeout settings
By using [Detail] tab-[Timeout Settings], the
timeout value is set.
The [Not Selected] box indicates the number it
will take in seconds for a printer to become
available for printing, from the time the computer
starts outputting print data. If the waiting time
exceeds value set, a printer error is shown and
the job is automatically cancelled.
The [Transmission retry] box is used to set the
amount of time in seconds until a printer to become available for printing allowing a computer that
failed to output once to output the print data again. If the waiting time exceeds this set value, a
printer error is shown and the job is automatically cancelled.
3-20 IP-011 Printer Controller
1- Left (portrait)
1- Right (portrait)
2-Left (portrait)
2- Top (portrait)
1- Left (landscape)
1-Right (landscape)
2-Left (landscape)
2-Top (landscape)