Handlebar Switches - Yamaha BIG BEAR 400 Owner's Manual

EBU18061

Handlebar switches

4
1. Light switch " /
2. Start switch " "
3. Engine stop switch "
4. Override switch "OVERRIDE"
EBU18080
Engine stop switch "
Set this switch to "
The engine stop switch controls the ignition and
stops the engine when it is running. Use this switch
to stop the engine in an emergency situation. The
engine will not start or run when this switch is set
to " ".
/OFF"
/ "
/ "
" before starting the engine.
EBU18100
Start switch " "
Push this switch to crank the engine with the start-
er.
ECB00050
CAUTION:
See the starting instructions on page 6-1 prior
to starting the engine.
EBU18160
Light switch "
Set this switch to "
the taillight and the meter lighting. Set the switch to
" " to turn on the high beams, the taillight and
the meter lighting. Set the switch to "OFF" to turn
off all the lights.
ECB00040
CAUTION:
Do not use the headlights with the engine
turned off for an extended period of time, oth-
erwise the battery may discharge to the point
that the starter motor will not operate properly.
If this should happen, remove the battery and
recharge it.
4-5
/ /OFF"
" to turn on the low beams,