Speedometer - Yamaha BIG BEAR 400 Owner's Manual

If the warning light stays on, allow the engine to
cool. If the warning light stays on when the engine
is cool, have a Yamaha dealer check the electrical
circuit.
ECB00010
CAUTION:
G The engine may overheat if the ATV is over-
loaded. In this case, reduce the load to spec-
4
ification.
G
Start the engine after making sure that the
warning light is out. Continuous use while
the warning light is on may cause damage to
the engine.
EBU17952
On-Command four-wheel-drive indicator light
" "
This indicator light comes on when the On-Com-
mand four-wheel-drive switch is set to the "4WD"
position.
NOTE:
Due to the synchronizing mechanism in the differ-
ential gear case, the light may not come on until
the ATV starts moving.
EBU28341
On-Command differential gear lock indicator
light " "
This indicator light and the On-Command four-
wheel-drive indicator light " " come on when the
On-Command differential gear lock switch is set to
the "LOCK" position.
EBU18020

Speedometer

The speedometer shows the riding speed. This
speedometer is equipped with an odometer and a
tripmeter. The tripmeter can be reset to "0" with the
reset knob. Use the tripmeter to estimate how far
you can ride on a tank of fuel before going to re-
serve. This information will enable you to plan fuel
stops in the future.
4-3