Speedometer/Tachometer/Digital Gauge - Yamaha SR10RE Operator's Manual

Speedometer/
Tachometer/Digital
Gauge
A. Coolant Temperature
Indicator
The indicator and LOW TEMP display
will cease to flash when the engine
reaches proper operating temperature.
If the coolant temperature rises too far
above proper operating temperature, the
indicator will flash a warning (alert) and
the engine will "surge" to alert the opera-
tor. If the coolant temperature rises to a
critical point above proper operating tem-
perature, the indicator will cease flashing
and will remain constantly illuminated.
 NOTE: If the indicator is constantly
on, the engine will shut off if vehicle
speed is reduced to 1.5 km-h (0.9
MPH) or slower.
CAUTION
If the indicator is illuminated, stop the
engine immediately and allow it to cool
down. If unable to either determine or
remedy the problem, take the snowmo-
bile to an authorized Yamaha Snowmo-
bile dealer for service. If not under
warranty, this service is at the discretion
and expense of the snowmobile owner.
B. High Beam Indicator
The indicator is on whenever the high
beam mode is selected by the headlight
switch.
C. Oil Pressure Indicator
The indicator relates to engine oil pres-
sure, not the oil level; however, if the oil
level is low, it may affect oil pressure. If
oil pressure is lost, check the oil level
(see page 21).
If the indicator does not go out or if the
engine does not start, take the snowmo-
bile to an authorized Yamaha Snowmo-
bile dealer. If not under warranty, this
service is at the discretion and expense of
the snowmobile owner.
D. Low Fuel Indicator
The indicator illuminates whenever the
gas in the gas tank is low.
E. Coolant Temperature/
Battery Voltage/Intake Air
Temperature
CWI-050A
This bar display shows coolant tempera-
ture, battery voltage, intake air tempera-
ture, and on
temperature. Press the Lower Left Button
to change which parameter is being dis-
played. Press and hold the Lower Left
Button to see the actual values associated
with the mode selected.
F. Fuel Level Display
This display shows the approximate
amount of gas remaining in the gas tank.
G. RPM/Speed/Clock/
Altimeter
Press the Upper Left Button to cycle the
left screen between RPM and speed.
 NOTE: When RPM is displayed on
the left screen, the right screen will
display speed, clock, or altimeter.
When speed is displayed on the left
screen, the right screen will display
RPM, clock, or altimeter.
Press the Upper Right Button to cycle the
right screen between speed, RPM, clock,
and altimeter.
Press and hold the Upper Button on the
speed-side of the gauge to shift the gauge
between standard (MPH/miles/fahren-
heit) and metric (km/h/kilometers/cel-
sius) modes.
Press and hold the Upper Button on the
RPM-side of the gauge to view maxi-
mum RPM. This value is reset each time
the ignition key is turned off.
the 6000, exhaust
5