Replacing The Fuses; Replacing The Headlight Bulb - Yamaha VIRAGO XV250P Owner's Manual

PERIODIC MAINTENANCE AND MINOR REPAIR
1. Main fuse
2. Signaling system fuse

Replacing the fuses

The main fuse and the signaling sys-
tem fuse holders are located under the
6
rider seat. (See page 3-8 for rider seat
removal and installation procedures.)
If a fuse is blown, replace it as follows.
1. Turn the key to "OFF" and turn off
the electrical circuit in question.
2. Remove the blown fuse, and then
install a new fuse of the specified
amperage.
Specified fuses:
Main fuse:
Signaling system fuse:
CAUTION:
_
Do not use a fuse of a higher amper-
age rating than recommended to
avoid causing extensive damage to
the electrical system and possibly a
fire.
EAU03610*
_
3. Turn the key to "ON" and turn on
the electrical circuit in question to
check if the device operates.
4. If the fuse immediately blows
again, have a Yamaha dealer
check the electrical system.
20 A
10 A
EC000103
1. Screw ( 2)

Replacing the headlight bulb

This motorcycle is equipped with a
quartz bulb headlight. If the headlight
bulb burns out, replace it as follows.
1. Remove the headlight unit by re-
6-32
moving the screws.
EAU03003