Yamaha VIRAGO XV250P Owner's Manual page 74

1. Wheel axle
2. Front wheel axle pinch bolt
2. Loosen the front wheel axle pinch
bolt, then the wheel axle.
3. Lift the front wheel off the ground
according to the procedure on
page 6-34.
4. Pull the wheel axle out, and then
remove the wheel.
CAUTION:
@
Do not apply the brake after the
wheel has been removed together
with the brake disc, otherwise the
brake pads will be forced shut.
@
PERIODIC MAINTENANCE AND MINOR REPAIR
1. Speedometer gear unit
To install the front wheel
1. Install the speedometer gear unit
into the wheel hub so that the pro-
jections mesh with the slots.
2. Lift the wheel up between the fork
legs.
NOTE:
ECA00048 _
Make sure that there is enough space
between the brake pads before insert-
ing the brake disc and that the slot in
the speedometer gear unit fits over the
retainer on the fork leg.
_
3. Insert the wheel axle.
4. Lower the front wheel so that it is
on the ground.
1. Speedometer gear unit
2. Retainer
EAU04183
3. Speedometer cable
5. Push down hard on the handlebar
6. Tighten the wheel axle to the
7. Tighten the front wheel axle pinch
6-35
several times to check for proper
fork operation.
specified torque.
Tightening torque:
Wheel axle:
59 Nm (5.9 m·kgf, 43 ft·lb)
bolt to the specified torque.
6