Yamaha VIRAGO XV250P Owner's Manual page 49

PERIODIC MAINTENANCE AND MINOR REPAIR
1. Bolt ( 3)
2. Oil filter element cover
4. Remove the oil filter element cover
by removing the bolts.
5. Remove and replace the oil filter
element and O-ring.
6
6. Install the oil filter element cover
by installing the bolts, then tighten-
ing them to the specified torque.
Tightening torque:
Oil filter element cover bolt:
7 Nm (0.7 m·kgf, 5.1 ft·lb)
NOTE:
@
Make sure that the O-ring is properly
seated.
@
1. Oil filter element
2. O-ring
7. Install the engine oil drain bolt, and
then tighten it to the specified
torque.
Tightening torque:
Engine oil drain bolt:
34 Nm (3.4 m·kgf, 25 ft·lb)
8. Add the specified amount of the
recommended engine oil, and
then install and tighten the oil filler
cap.
6-10
Recommended engine oil:
See page 8-1.
Oil quantity:
With oil filter element
replacement:
1.6 L (1.4 Imp qt, 1.7 US qt)
Without oil filter element
replacement:
1.4 L (1.2 Imp qt, 1.5 US qt)
Total amount (dry engine):
1.8 L (1.6 Imp qt, 1.9 US qt)
CAUTION:
@
In order to prevent clutch slip-
page (since the engine oil also
lubricates the clutch), do not
mix any chemical additives with
the oil or use oils of a higher
grade than "CD". In addition, do
not use oils labeled "ENERGY
CONSERVING II" or higher.
Make sure that no foreign mate-
rial enters the crankcase.
@
EC000072