Lubricating The Drive Chain; Checking And Lubricating The Cables - Yamaha VIRAGO XV250P Owner's Manual

Lubricating the drive chain

The drive chain must be cleaned and
lubricated at the intervals specified in
the periodic maintenance and lubrica-
tion chart, otherwise it will quickly wear
out, especially when riding in dusty or
wet areas. Service the drive chain as
follows.
CAUTION:
@
The drive chain must be lubricated
after washing the motorcycle or
riding in the rain.
@
1. Clean the drive chain with kero-
sene and a small soft brush.
CAUTION:
@
To prevent damaging the O-rings,
do not clean the drive chain with
steam cleaners, high-pressure
washers or inappropriate solvents.
@
2. Wipe the drive chain dry.
3. Thoroughly lubricate the drive
chain with a special O-ring chain
lubricant.
PERIODIC MAINTENANCE AND MINOR REPAIR
EAU03006
CAUTION:
@
Do not use engine oil or any other
lubricants for the drive chain, as
they may contain substances that
could damage the O-rings.
@
EC000097
ECA00053
ECA00052
Checking and lubricating the
cables
The operation of all control cables and
the condition of the cables should be
checked before each ride, and the ca-
bles and cable ends should be lubricat-
ed if necessary. If a cable is damaged
or does not move smoothly, have a
Yamaha dealer check or replace it.
@
Damage to the outer housing of ca-
bles may result in internal rusting
and cause interference with cable
movement. Replace damaged ca-
bles as soon as possible to prevent
unsafe conditions.
@
6-25
Recommended lubricant:
Yamaha Chain and Cable Lube
or engine oil SAE 10W-30
(API SE)
WARNING
EAU03297
6
EW000111