Information - Toshiba D-VR16SB Owner's Manual

Recording
Timer Recording (cont'd)
Notes
• If you have not set the clock, the clock setting window will appear instead of the Timer Programming list at step 1. In this case,
press [ENTER]. Then continue from step 4 in "Manual Clock Setting" on page 34 before programming the timer recording.
• Press [s / B] to move the cursor in the timer programming list.
• If a basic recording or One-touch Timer Recording is in progress on one component (e.g. VCR) and the timer recording set
for the other component (e.g. DVD) is about to begin, the unit automatically switches to the programmed channel for timer
recording 2 minutes before the programmed starting time, and the recording in progress (for VCR) will be cancelled
UNLESS their recording channels are the same. If their recording channels are the same, the timer recording will start
without cancelling the recording currently in progress. In this case, the recording of the same channel will be made on both
DVD and VCR.
• Cancel the timer-standby mode by pressing [T-SET] before operation for either DVD or VCR. When finished operating,
press [T-SET] to resume the timer-standby mode.
52 EN
8
Select PDC to "ON" or "OFF" using [K / L].
(See page 54.)
Timer Programming
Date Start End
1. 01/01 12:57 13:57 P08 DVD
2. ---
3. ---
4. ---
5. ---
6. ---
7. ---
8. ---
9
Press [ENTER] when all information required
is entered.
Your programme setting is stored.
• To set another programme, repeat steps 2 to 9.
• To exit, press [TIMER PROG].
• If the recording times of two or more programmes overlap,
"Overlap" and overlapped programme numbers are
displayed. (See pages 53-55.)
10
Press [T-SET].
The icon will appear on the front panel display and the unit
is set to the timer-standby mode.
• Timer Recording will not work when the power is on.
• When power is on, programmes registered for recording in
Timer Recording will be automatically cleared after the end
time and date have passed.
To stop the timer recording in progress
Press [C (STOP)] on the front panel to stop the disc
recording.
Press [A / C (EJECT / STOP)] on the front panel to stop
the tape recording.
• [STOP C] on the remote control is not effective.
VCR DVD
DVD
CH Mode PDC
VCR
SP ON