Toshiba Satellite 2430 User Manual page 190

S4 Response formatting character (user defined)
S5 Command line editing character (user defined)
S6 Wait before dialling
Satellite 2430 Series
This register determines the ASCII value used as the line feed
character. The modem uses a line feed character in command
mode when it responds to the computer.
Range: 0-127, ASCII decimal
Default: 10 (line feed)
Units: ASCII
This register sets the character recognised as a backspace and
pertains to asynchronous only. The modem will not recognise
the backspace character if it is set to a value that is greater than
32 ASCII. This character can be used to edit a command line.
When the echo command is enabled, the modem echoes back
to the local DTE the backspace character, an ASCII space
character, and a second backspace character. This means a
total of three characters are transmitted each time the modem
processes the backspace character.
Range: 0-127, ASCII decimal
Default: 8 (backspace)
Units: ASCII
This register sets the length of time, in seconds, that the modem
must wait (pause) after going off-hook before dialling the first
digit of the telephone number. The modem always pauses for a
minimum of two seconds, even if the value of S6 is less that two
seconds. The wait for dial tone call progress feature (W dial
modifier in the dial string) will override the value in register S6.
This operation, however, may be affected by some ATX options
according to country restrictions. In some countries, S6 will set
dial tone detect time.
Range: 2-65
Default: 4 or 12
Units: seconds
S-registers
I-3