Toshiba Satellite 2430 User Manual page 175

Dn Dial
Refer to the section Country select command and S-register in Appendix I
for country-specific codes.
En Echo command
Satellite 2430 Series
This command instructs the modem to dial a telephone number.
Enter n (the telephone number and any modifiers) after the ATD
command.
Any digit or symbol (0-9, *, #, A, B, C, D) may be dialled as
touch-tone digits. Characters such as spaces, hyphens, and
parentheses do not count. They are ignored by the modem, but
you may want to include them to make the number and
modifiers easier to read.
The following may be used as phone number modifiers:
P Pulse dialling.
T Touch-tone dialling (default).
Pause during dialling. Pause for time specified in
,
Register S8 before processing the next character in the
dial string.
W Wait for dial tone. Modem waits for a second dial tone
before processing the dial string.
@ Wait for quiet answer. Wait for five seconds of silence
after dialling the number. If silence is not detected, the
modem sends a NO ANSWER result code back to the
caller.
! Hook flash. Causes the modem to go on-hook for 0.5
seconds and then return to off-hook.
; Return to command mode. Causes the modem to
return to command mode after dialling a number,
without disconnecting the call.
Dial a telephone number previously stored using the
S=n
&Zn=X command (See &Zn=X command for more
information). The range is 0-3.
This command controls whether or not the characters entered
from your computer keyboard are displayed on your monitor
(echoed) while the modem is in command mode.
E0 Disables echo to the computer.
E1 Enables echo to the computer (default).
Result Codes:
OK
n=0,1
ERROR Otherwise
AT Commands
H-3