Table of Contents
Advertisement
Preparations
Settings
Initial settings of the DZC-PSC2
The DZC-PSC2 PetaSite Control Software has been
installed on the PCU, and the required initial settings
have been made at the factory. Depending on the
environment, the initial settings may be changed.
For changing the initial settings, refer to on-line help for
the DZC-PSC2. To refer to on-line help, click on the Help
button of the MMT window of the DZC-PSC2.
Starting the DZC-PSC2
Follow the procedures below to start the DZC-PSC2.
1
Turn the PCU on.
2
Type "sonypsc" in the Username box, and
"psc2002" (initial password) in the Password box
of the Login window.
3
Click on the PetaApp icon on the desktop.
If you wish to change the initial password, refer to on-
line help for the DZC-PSC2.
Log in as a root user
To log in with the account root for the administrator,
type "root" in the Username box, and "sony2002"
(initial password) in the Password box.
To change the password
Proceed as follows.
1
Log in with the user name whose password is to be
changed.
2
Open the Terminal window, type "passwd," and
press the Enter key.
3
Enter the original password at the prompt.
4
Enter the new password twice, at the prompts.
Then the new password will be effective upon the next
log-in.
14(E)
Setting the host name and IP address of
the PCU
The PCU has several files keyed with the host name
and IP address. Before starting operation of the CSM
System, set the host name and IP address, and reflect
them in these files. Set the host name and IP address
following the procedure below, then the settings will
be reflected in the files.
Note
The host name and IP address can not be changed after
starting operation of the CSM System. If you need to
change them, contact to Sony support center.
1
Type "root" in the Username box to log in, and
open the Terminal window.
2
Click on the PetaApp icon on the desktop.
3
Click on the Utility icon to open the Utility
window.
4
Select "Administrator" from the Mode list box at
the right top on the Utility window.
5
Type "sony" (initial password) in the Password
box.
6
Click on the Network tab of the Utility window.
7
Read the notice, then click on Network
Configurator at the bottom of the window to start
Network Configurator.
8
Type the new host name in the HostName column,
and the new domain name in the Domain column
in the Names window.
9
Add the host name and IP address relationships
required for operating the new host and the IP
address in the Hosts window.
10
Change the IP address for eth1 to the new IP
address in the Interface window.
11
Click on the SAVE button in the Network
Configurator window to retain the settings.
12
Click on the Cancel button to close the PetaApp
utility window.
Advertisement
Table of Contents
