Sharp MD-R3 Operation Manual page 39

(Continued)
ENTER
(Timer confirmation mode)
(Timer cancel mode)
To check the timer setting
DELETE/CLEAR
1
While in the timer stand-by mode, press the TIMER button.
TIMER
2
Turn the jog dial until "TIMER CALL" appears.
3
Press the ENTER button within 10 seconds.
The timer settings will appear in order, and then the original
display will reappear.
To cancel the timer operation
When the power is turned on, the timer will be canceled.
The timer operation can also be canceled as follows.
1
While in the timer stand-by mode, press the TIMER button.
2
Turn the jog dial until "TIMER CANCEL" appears.
3
Press the ENTER button.
The timer operation will be canceled. ("TIMER" or "TIMER
REC" will go out.) The start and stop times will still be stored.
Notes:
When the CD or MD is played to the end, playback will stop
before the stop time.
If you wish to play to the stop time, set repeat play for the
CD or MD.
This timer in this unit cannot be used to control equipment
connected to this unit. You must use the timer in the other
equipment, if it has one.
The timer playback and timer recording functions cannot be
used at the same time.
In the following cases, the timer recording function will not work.
When a MiniDisc has not been inserted.
When a playback-only MiniDisc is inserted.
When the MiniDisc you inserted is protected against acciden-
tal erasure.
When there is no recording space left on the MiniDisc you
inserted (when the "TOC FULL" or "DISC FULL" messages
appear).
38
MD-R3