How To Use The Built-In Timer - Sharp MD-R3 Operation Manual

HOW TO USE THE BUILT-IN TIMER

Before setting the timer, make sure that the clock setting is correct. (Pages 8 - 9)
The start time and stop time, which are set with this operation, will be kept in memory until the AC power cord is
unplugged or the setting is changed.
ENTER
1
2
3
4
5
The stop time setting display will appear.
The "hours" display will be automatically increased one hour.
6
7
8
1
(Timer standby mode)
2
TIMER
Timer playback indicator
Timer playback
DELETE/CLEAR
TIMER
Before timer playback, the following preparations are required.
Load a CD or MD.
Select a CD to be played.
1
While in the stop mode, press the TIMER button, and then
turn the jog dial until "TIMER SET" appears.
2
Within 10 seconds, press the ENTER button, and then select
"TIMER PLAY" using the jog dial.
3
Press the ENTER button.
The start time setting display will appear.
4
Enter the "hour", using the jog dial. Then, press the ENTER
button.
5
Enter the "minute", using the jog dial. Then, press the ENTER
AM
button.
The stop time setting display will appear.
AM
6
Enter the "hour", using the jog dial. Then, press the ENTER
button.
AM
7
Enter the "minute", using the jog dial. Then, press the ENTER
button.
AM
The start and stop times are now set.
8
Select the source program using the jog dial.
AM
MD CD
9
Press the ENTER button.
Setting for timer playback:
AM
1
Press the TIMER button, and then select "T-STANDBY" using
the jog dial.
AM
2
Press the ENTER button.
AM
The settings will appear in order, and the unit will enter the
timer playback stand-by mode. (The power will be turned off.)
Preparations for any equipment connected to this unit
Any equipment, such as a stereo, that is connected to this unit
should be set up in advance as follows:
Adjust the sound level of the equipment.
If it has a timer function, set it so that the power will be
turned on at the same time as the timer's start time.
Adjust the playback volume.
36
MD-R3