Sharp MD-R3 Operation Manual page 24

(Continued)
RECORD
INPUT
SELECT
MIC
ENTER RECORD
REC
1
12 4
8 9 10 11 12 13
15 16 17 18
(When recording starting from 3 minutes
and 32 seconds into the fourth track)
2
8 9 10 11 12 13
15 16 17 18
3
TOC 12 4
1 2 3 4 5
4
TOC 12 4
1 2 3 4 5
Recording from the microphone
1
Connect the stereo microphone to the MIC jack on the main
REC LEVEL
unit.
MIN
MAX
2
Insert a recordable MiniDisc.
3
Press the INPUT SELECT button until "ANALOG" appears.
4
Press the RECORD button.
The unit will enter the recording stand-by mode.
5
Adjust the recording level using the REC LEVEL control.
Adjust the recording level so that the maximum level does
not exceed "0 dB".
6
Press the MD
Recording will start.
To interrupt a recording:
Press the MD
The unit will enter the recording stand-by mode.
To resume recording, press the MD
The track number will increase by one each time you interrupt
a recording.
To stop recording:
Press the MD
To re-record
When you want to re-record a track, erase the previously re-
corded track and start a new recording, or start recording from
any point within the old track. If you start recording from within
a track, all of the tracks and track names that follow will be
MD
erased. If you want to erase all of the tracks and re-record the
disc, you can erase all of the tracks using the all erase function.
Then you simply perform the normal recording operations. (Page
30)
1
During playback, press the MD
you want to begin re-recording.
0dB OVER
4 5 6 7
The unit will pause.
14
2
Press the RECORD (REC) button.
To cancel the operation, press the MD
3
Press the ENTER button.
The unit will be in the recording pause mode.
4 5 6 7
14
4
Select the recording source and start recording.
0dB OVER
0dB OVER
23
MD-R3
06
button.
06
button while recording.
06
button again.
button.
06
button at the point where
button.