Connecting/Using Other Devices; Registering Handsets - Siemens Gigaset DX800A User Manual

Connecting/using other
devices
You can upgrade your base to a "PABX" by
connecting other communication devices.
You can register up to six handsets and six
Gigaset repeaters to your base.
Each registered device is assigned an inter-
nal number (2–7) and an internal name
(INT 2–INT 7). You can change the number
assignment and names.
If all internal numbers have already been
assigned on your base, you must deregister
a handset that is no longer required before
registering a new one.
You can also connect an analogue fax
¢
machine ( page 123,
six Bluetooth devices (one headset and a
total of five GSM mobiles/data devices,
¢
page 117).

Registering handsets

You must register a handset on the base (1)
and on the handset itself (2).
1. On the base:
To set the base to registration mode:
¢ ¢
Ï
v
Registration
¢
Register Handset
The base's DECT interface is (assuming it is
deactivated) automatically activated as
soon as you set the base to registration
mode.
You can register the handset as long as the
display on the base shows the message
Please register your handset.
¢
page 140) and

Connecting/using other devices

2. On the handset:
Within approx. 60 seconds.
¤
Start the registration procedure on the
handset in accordance with the hand-
set's user guide.
You are asked to enter the current system
PIN of the base on your handset (default
setting: 0000).
~
Enter the current system PIN
and press
After registering successfully
Handset registered is shown on the base's
display.
Please note
If six handsets are already registered to the
base (the internal numbers 2–7 are already
assigned), you have two options:
u
The handset assigned the internal
number 7 is in idle status:
The handset that previously had the
number 7 is deregistered; the new hand-
set is registered and is assigned the
internal number 7.
u
The handset assigned the internal
number 7 is in use:
The handset to be registered cannot be
registered. A message to this effect is
displayed on the handset.
Assigning send and receive
connections to the handset
If several connections are configured on the
base, the connection wizard for the handset
is started automatically. This enables you to
assign send and receive connections to the
handset. For information on the connection
wizard procedure see
§OK§
.
page 32.
113