Installing The Base Station And Charging Cradle; Connecting The Base Station - Siemens Gigaset E490 User Manual

Installing the base station and charging cradle

The base station and charging cradle are designed for use in enclosed dry rooms
with a temperature range of +5°C to +45°C.
¤
Place the base station in a central location in your flat or house. Position the base
station and charging cradle on a level, non-slip surface or mount them on the
¢
wall
Please note
u
Pay attention to the range of the base station.
This is up to 300 m in unobstructed outdoor areas and up to 50 m inside
buildings.
u
The range is reduced when eco mode is on (
The phone's feet do not usually leave any marks on surfaces. However, due to the
multitude of different varnishes and polishes used on today's furnishings, the
occurrence of marks on the surfaces cannot be completely ruled out.
Please note:
u
Never expose the telephone to the influence of heat sources, direct sunlight or
other electrical devices.
u
Protect your Gigaset from moisture, dust, corrosive liquids and vapours.

Connecting the base station

¤
First connect the
mains adapter 1.
¤
Then connect the
telephone jack
and insert the
cables into the
cable ducts.
Please note:
u
The mains adapter must always be connected, as the phone will not operate
without mains connection.
u
Only use the mains adapter and phone cord supplied. Pin connections on tele-
phone cables can vary (pin connections
page 67.
2
¢
page 44).
2
¢
page 63).
First steps
1
1
7