Table of Contents
Advertisement
F
Children can be harmed by small parts, sharp edges and sharp points
in the vehicle's unassembled state, or by electrical items. Care should be taken
in unpacking and assembly of the vehicle. Children should not handle parts,
1
Vehicle
Body
• Lift to remove the vehicle body from the vehicle frame.
2
Taillight
Cover
Taillight
• Position the taillight cover with the inside arrow
pointing upward.
• Fit the taillight cover to the taillight.
• Insert two #8 x
1
/
" screws through the holes in the
2
taillight cover and into the taillight.
• Tighten the screws with a Phillips screwdriver.
Do not over-tighten.
Assembly
including the battery, or help in assembly of the vehicle.
Vehicle
Frame
Arrow
Points Up
WARNING
3
Taillight
3
#8 x
/
" Screw
4
Vehicle Body
Rear Fender
• Position the vehicle body upside down on a flat surface.
• Fit the taillight to the outside of the vehicle body rear
fender, as shown. Make sure the holes in the vehicle
body rear fender and taillight are aligned.
• First, insert one #8 x
edge of the vehicle body rear fender and into the taillight.
• Next, insert two #8 x
holes in the vehicle body rear fender and into the taillight.
• Tighten the screws with a Phillips screwdriver.
Do not over-tighten.
11
#8 x
1
#8 x
1
/
" screw through the hole near the
2
3
/
" screws through the remaining
4
/
" Screw
2
3
/
" Screw
4
Advertisement
Table of Contents
