Decorative Glass And Rock Media Accessory Installation - Empire Comfort Systems FG28BMK(N,P)-1 Installation Instructions Manual

DECORATIVE GLASS AND ROCK MEDIA ACCESSORY INSTALLATION

Failure to position the parts in accordance with the dia-
grams and instructions below or failure to use only parts
specifically approved for use with this heater may result in
property damage or personal injury.
Notice: The G-Class series Mantis may be operated with or
without the Decorative accessory options. Follow the
directions below should you choose to enhance your
fireplace with any one of the available decorative op-
tions.
DECORATIVE GLASS OR ROCK MEDIA ACCESSORY
PLACEMENT
Note: The G-Class Series Mantis fireplace will accept two square
feet of decorative media.
Empire Comfort Systems offers a selection of decorative media
for the G-Class series Mantis fireplace. It is approved for use with
glass media measuring as small as 1/4 inch and up to 1-1/4 inch
in diameter. See page 7. Additional colors may be available from
your Empire dealer. Empire Comfort Systems approved rock me-
dia may also be used. See page 7.
Use properly sized media - crushed, smooth, small, large, or a
combination - to create the desired look. Follow the diagrams in
this manual for placement of media and clearance to burner open-
ings.
Use of gloves and eye protection is required while applying
the decorative glass.
Use only decorative glass media approved for use in gas
fireplaces.
Use only Empire Comfort Systems approved decorative
rock media.
Page 38
WARNING
CAUTION
CAUTION
CAUTION
INSTALLATION
1. Application of the Decorative Media should only be performed
after the fireplace has been fully installed, secured and tested
for leaks.
2. To install the Decorative Media, cut off a corner of the plastic
bag and proceed to apply the media to the rear of the porce-
lain liner bottom (area behind the burner). Apply only enough
media to the porcelain liner bottom to cover the black metal
surface. Do not allow the media to fall around the burner tube.
See Figures 59 to 61. Apply the remaining decorative media
to the front area of the porcelain liner bottom. Start by placing
the media along the front of the porcelain liner bottom, then
gradually place the media up the porcelain liner bottom until
completely covered. Do not allow the media to fall around the
burner tube. See Figures 59 to 61.
Never stack decorative media higher than the 1/2 inch burn-
er opening flanges when within two inches of the burner
opening. See Figure 62.
CAUTION
31793-3-1015