SOYO SY-P4VGA User Manual page 91

When I boot up my new computer I get "floppy boot failure" and the
LED on the floppy stays on
1. Make sure the red wire of floppy ribbon cable goes to Pin1 on the
floppy drive side (don't trust the "key lock" or "notch") and use
the end-connector of the cable (don't use middle one).
2. Some floppy drivers have their own jumper to make the same
twist as the twist on the cable. Make sure this jumper is set not to
"twist" the cable while the floppy drive is connected to the
twisted end of the cable.
LAN Issues
During LAN driver installation, the system hangs on 75%, why?
Enable the onboard LAN in the BIOS setup.
I have problems installing Novell NetWare v.50
Disable the APIC option in the BIOS.
For updated FAQs, please check
http://www.soyousa.com/faqs.html
http://www.soyo.com.tw/faq.htm
87
or