Connecting Lcd Tv; Connecting Ac Power Cord; Installing Stand; Preventing The Tv From Falling Over - Sanyo LCD-32K40TD Instruction Manual

CONNECTING AC POWER CORD

This LCD TV uses nominal input voltages of 110-242V AC. This
LCD TV automatically selects the correct input voltage. It is
designed to work with single-phase power systems. To reduce
risk of electric shock, do not plug into any other type of power
system. Consult your authorized dealer or service station if you
are not sure of the type of power being supplied.
Connect the LCD TV with all peripheral equipment before
turning the LCD TV on.
CAUTION
For safety, unplug AC power cord
when the LCD TV is not in use.
Please according to the following procedure to installing stand.
1
Be careful of the panel. Suggest to put
down the panel side on the cushion or other
soft material before installing the stand.
Installing of stand is completed.
3

PREVENTING THE TV FROM FALLING OVER

Carry out the steps given below to stabilize the TV that it will
be safe in the event of a disaster such as an earthquake, and
so that it will not fall over during normal use.
Use the marketed bands and screws C to fasten the TV
securely to the TV stand etc.
Screw C

CONNECTING LCD TV

Pull the AC power cord out from the LCD TV. The AC outlet
must be near this equipment and must be easily accessible.

INSTALLING STAND

To align the corresponding pilot holes and fix the
2
stand by screws.
Screws B for LCD-32K40-TD: 4 pcs
Screws A for LCD-42K40-TD: 2 pcs
Screws B for LCD-42K40-TD: 4 pcs
Note: Screws A are just for
Mounting
screw C
AC POWER CORD
To the AC Outlet (110 - 242V AC).
A
B
B
LCD-42K40TD
Band
Mounting
Mounting
screw C
screw C
Screw A
Screw B
Mounting
screw C
Band
9