Messages And Signals - Sharp UX-BS60 Operation Manual

Messages and Signals

Display messages
Note: If you have turned on the Caller ID function, see page 100 for display
messages related to Caller ID.
ADD PAPER & /
PRESS START KEY
(alternating messages)
A.M. MEMORY FULL
A.M. TRANSFER
CHANGE CARTRIDGE
CHECK CARTRIDGE
DOCUMENT JAMMED
FAX MEMORY FULL
Check the printing paper. If the tray is empty, add
paper and then press
tray, make sure it is inserted correctly (take out the
stack, align the edges evenly, and then reinsert it in
the tray) and then press
The answering machine's message memory is full.
Erase recorded messages as explained on page 52.
The answering machine's transfer function has been
turned on (see page 55).
This message appears after you install or replace the
print cartridge (see page 19).
The print cartridge is missing and must be installed,
or is not installed correctly.
The original document is jammed. See the following
section, Clearing Paper Jams . Document jams will
occur if you load more than 10 pages at once or load
documents that are too thick (see page 66). The
document may also jam if the receiving machine
doesn't respond properly when you attempt to send a
fax.
The document memory is full. If faxes have been
received to memory because printing is not possible
(an additional message will indicate the problem),
resolve the problem so that printing can continue (see
Substitute Reception to Memory on page 95).
If you are attempting to transmit from memory, see If
the memory becomes full on page 86.
If you are copying, see If MEMORY IS FULL appears
on page 97.
Messages and Signals
START/
MEMORY
. If there is paper in the
START/
.
MEMORY
125