Adjusting The Clamp Position / Picture Mute Function - Panasonic PT-D9510E Operating Instructions Manual

Adjusting the clamp position
• If the black portions of the picture are fractured or tinged with green, adjust the clamp position its optimum
state.
Adjustment procedure
Optimum value for clamp position adjustment
• If the black sections are fractured
• If the black sections are tinged with green
Picture mute function
The projector has a picture mute capability that allows you to put the image off instantaneously. To mute the
image, press the PIC-MUTE button on the projector or remote control. To reset picture mute, press the PIC-MUTE
button a second time.
Press the MENU button. ... The MENU screen will be displayed.
Press the UP ( ) and DOWN (
Press the ENTER button. ... The POSITION screen will be displayed.
Press the UP ( ) and DOWN (
NOTE
• The clamp position can be adjusted when an RGB signal has been input with the
analogue RGB module (ET-MD95RGB)
Press the ENTER button. ... The CLAMP POSITION screen will be displayed.
Press the LEFT ( )and RIGHT (
• The adjustment values will change from 0 (min.) to 254 (max.)
The optimum value is when the fracturing of the black sections
is at a minimum.
Optimum value is when the green portion turns black but is not
smudged.
) arrow buttons to select POSITION.
) arrow buttons to select CLAMP POSITION.
) arrow buttons to adjust.
53