Panasonic PT-D9510E Operating Instructions Manual page 29

Installing the input modules
Disconnect the power supply from the projector before installing any of the input modules.
Installation procedure
Remove the two screws which are holding the slot cover where the input module is to be installed, and then
remove the slot cover.
Fit the input module into the slot rails, and then push the input module in until it is seated in the connector, while
being careful not to bump any of the module components.
Tighten the two screws to secure module in place.
NOTE • Up to three input modules can be installed.
• Do not remove any of the covers on spare slots
where no input module has been installed.
• Be sure to install input modules in the slot 1,
slot 2 and slot 3 positions.
Remove the slot cover
Remove the
Slot cover
Insert the input module
Input module
Secure the input module
Tighten the two screws
Register input signal
• With this equipment, it is necessary
to store the input signal after
installing the input module. (Refer to
pages 42 and 43 for details on
registering input signals.)
two screws
Slot
29