Adjusting The Clamp Position / Picture Mute Function - Panasonic PT-D9610U Operating Instructions Manual

Adjusting the clamp position
• If the black portions of the picture are fractured or tinged with green, adjust the clamp position its optimum
state.
Adjustment procedure
MENU
AUTO SETUP
LENS
PICTURE
POSITION
OPTION
SIGNAL LIST
TEST PATTERN
MENU :
SUB MENU : ENTER
EXIT : MENU
POSITION
SHIFT
SIZE
BLK
CLOCK PHASE
INPUT RESOLUTION
CLAMP POSITION
KEYSTONE
EDGE BLENDING
MENU :
SUB MENU : ENTER
EXIT : MENU
CLAMP POSITION
POSITION : MIN
ADJUST :
EXIT : MENU
Optimum value for clamp position adjustment
• If the black sections are fractured
• If the black sections are tinged with green
Picture mute function
The projector has a picture mute capability that allows you to put the image off instantaneously. To mute the
image, press the PIC-MUTE button on the projector or remote control. To reset picture mute, press the PIC-MUTE
button a second time.
Press the MENU button. ... The MENU screen will be displayed.
Press the UP ( ) and DOWN (
Press the ENTER button. ... The POSITION screen will be displayed.
Press the UP ( ) and DOWN (
NOTE
• The clamp position can be adjusted when an RGB signal has been input with the
analog RGB module (ET-MD95RGB)
Press the ENTER button. ... The CLAMP POSITION screen will be displayed.
Press the LEFT ( )and RIGHT (
• The adjustment values will change from 0 (min.) to 254 (max.)
→ The optimum value is when the fracturing of the black sections
is at a minimum.
→ Optimum value is when the green portion turns black but is not
smudged.
) arrow buttons to select POSITION.
) arrow buttons to select CLAMP POSITION.
) arrow buttons to adjust.
53