Panasonic PT-D9510E Operating Instructions Manual page 38

Connecting the signal source to the input module for serial digital signals
2. 1) 480p single link (4:2:0p): 59.94 Hz progressive scan with 720 by 483 active lines at
360 Mbps, complying with the SMPTE294M Standard
2) 480i (4:2:2): 59.94 Hz interlace scan with 525 lines at 270 Mbps, complying with
the SMPTE294M Standard
3) 576i (4:2:2): 50 Hz interlace scan with 625 lines at 270 Mbps, complying with the
SMPTE294M Standard
• Use an input module which correctly matches the input signal type.
• Input modules that accommodate the 4 video signal formats described above can be switched from one to
another with the SYSTEM SELECTOR button that cycles through those signal formats. The selected input
signal is indicated by an OSD message that automatically goes off.
• The SYSTEM SELECTOR should normally be set in the AUTO position.
• The automatic scan format identification logic may malfunction if signal connections other than those
described above are employed or an unstable video signal is applied. In such an event, use the SYSTEM
SELECTOR button to select the scan format that matches the video signal format applied.
• To ensure correct video signal transmission, use 3C2W or better than 3C2W cables for video interconnections
(e.g., 3C2W, 3CFB, 4CFB, 5C2W, 5CFTX, 7CFB, etc.).
38
Serial digital input module(sold separately)
ET-MD95SD2 (for 480p/480i/576i)
MAIN IN MAIN OUT
SERIAL
480p Module
ET-MD95SD2
SD signal
Professional-type
digital VCR
SUB IN SUB OUT
• Leave the SUB IN/OUT terminals
open
SD Signal output
(Active through)